Solar Lights Outdoor, Motion Sensor Security Lights, Separate Solar Panel, 4 Adjustable Head, 198 LED 300° Wide Angle, Waterproof Wall Lights for Porch Yard Garage Pathway

Solor Lights Outdoor 198LED

2023 Multifunctional Solar Lights Outdoor Indoor - Super Bright LED Floodlights with Motion Sensor

Mode 1 --- Sensor mode: (Recommended).

The light does not normally turn on at night or when it is dark. When motion of a person or animal is detected, the light automatically switches to high intensity (2500lm) and turns off after about 20 seconds when there is no motion (recommended!!!).

Mode 2 --- DIM mode:

Automatically turns on low intensity (1000 lm) at night or when it is dark. The light automatically switches on at high intensity (2500 lm) when a person or animal comes within the detection range and returns to the low intensity lighting state when there is no longer any motion.

Mode 3---Permanent lighting mode:

The light is switched off during the day and in bright light. At night or when it gets dark, it automatically continues to be on at medium intensity (1800lm)

The split type solar lamp adopts 198 high-intensity LEDs and an innovative 4-head design. The 4 flexible lamp heads can rotate freely. The solar cell lamp panel can also be freely adjusted to face the sun to absorb solar energy with maximum efficiency. It is easy to customize the position you want to illuminate.

Warm Tips

1.Please turn the solar spot lights power switch to the “ON” position before first use. then press the gear switch or use the remote control to adjust the lighting mode.

2.The solar panel should be installed in the place with effective light to ensure it can fully absorbed adequate sunlight, so as to extended the working time of this solar pathway lights. Recommend a mounting height of 6- 12 feet.

3.the charging time and the lighting time of the solar outdoor decor lights may be affected by weather, season and installation location.

4.The third mode of this motion sensing security light is always on medium light, it can only light up 5-6 continuous hours. to save the battery power, we would recommend to use the first or second mode.

Precautions for use

1. Install the solar panel outside the light range of the host lamp. If you place it in the light range of the body light, you may experience flicker problems.
2. Please connect the power cable and charge the solar energy. It will not turn on during the day and may not turn on if there is a light source around the solar panel.
3. The motion sensor does not work until it is dark. When it is dark, it goes into standby mode.
4. Install in a location with sufficient direct sunlight. Do not install in the shade of trees or buildings.

Install front test light

First, turn on the light switch once. Shake the solar panel to prevent sunlight from being detected, wave your hand towards the sensor, and the sensor light will go on for 20 seconds. (Actual installation: At night, please install the solar panel outside the light range of the lamp body, generally placed above the lamp body)

When solar power is generated (when the solar panels shine), the sensors do not turn on even if they respond.

Q:What can be done about the flickering problem that occurs when outdoor solar lights are installed in a garage and then?

A:The reason is that the solar panel comes with a light source mode, the principle is to charge during the day and illuminate at night, if the solar panel is installed in a position where there are other light sources shining on the solar panel, it will not illuminate, so there will be problems such as flickering or even not working, it needs to be installed in full sunlight and without interference from other light sources.